ISCE_INSAR/contrib/stack

Stack Processors

Read the document for each stack processor for details.

• stripmapStack
• topsStack
• alosStack

Installation

To use a stack processor you need to:

1. Install ISCE as usual

2. Depending on which stack processor you need to try, add the path of the folder containing the python scripts to your $PATH environment variable as follows:

   • add the full path of your contrib/stack/topsStack to $PATH to use the topsStack for processing a stack of Sentinel-1 TOPS data
   • add the full path of your contrib/stack/stripmapStack to $PATH to use the stripmapStack for processing a stack of StripMap data
   • set environment variable $PATH_ALOSSTACK by doing: export PATH_ALOSSTACK=CODE_DIR/contrib/stack/alosStack to use the alosStack for processing a stack of ALOS-2 data

Note: The stack processors do not show up in the install directory of your isce software. They can be found in the isce source directory.

Important Note:

There might be conflicts between topsStack and stripmapStack scripts (due to comman names of different scripts). Therefore users MUST only have the path of one stack processor in their $PATH environment at a time, to avoid conflicts between the two stack processors.

References

Users who use the stack processors may refer to the following literatures:

For StripMap stack processor and ionospheric phase estimation:

• H. Fattahi, M. Simons, and P. Agram, "InSAR Time-Series Estimation of the Ionospheric Phase Delay: An Extension of the Split Range-Spectrum Technique", IEEE Trans. Geosci. Remote Sens., vol. 55, no. 10, 5984-5996, 2017. (https://ieeexplore.ieee.org/abstract/document/7987747/)

For TOPS stack processing:

• H. Fattahi, P. Agram, and M. Simons, “A network-based enhanced spectral diversity approach for TOPS time-series analysis,” IEEE Trans. Geosci. Remote Sens., vol. 55, no. 2, pp. 777–786, Feb. 2017. (https://ieeexplore.ieee.org/abstract/document/7637021/)